65D-Link DIR-625 User Manual
Section 4 - Security
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the router (192.168.0.1).
Click on Setup and then click Wireless Settings on the left
side.
2. Next to Security Mode, select WPA-Enterprise.
3. Next to WPA Mode, select WPA, WPA2, or WPA2 Only. Use
WPA2 if you have wireless clients using both WPA and WPA2.
4. Next to Cipher Mode, select TKIP, AES, or Auto.
5. Next to Group Key Update Interval, enter the amount of time
before the group key used for broadcast and multicast data is
changed (3600 is default).
6. Next to Authentication Timeout, enter the amount of time before
a client is required to re-authenticate (60 minutes is default).
6. Next to RADIUS Server IP Address enter the IP Address of your
RADIUS server.
7. Next to RADIUS Server Port, enter the port you are using with your RADIUS server. 1812 is the default port.
8. Next to RADIUS Server Shared Secret, enter the security key.
Configure WPA-Enterprise (RADIUS)
To Next Page
Loading...
Need help?
General
