D-Link DSL-2750E User Manual

DSL-2750E User Manual
5
 Multiple PVCs (eight at most) and these PVCs can be isolated from each
other
 A single PVC with multiple sessions
 Multiple PVCs with multiple sessions
 Binding of ports with PVCs
 802.1Q and 802.1P protocol
 DHCP server
 NAT and NAPT
 Static route
 Firmware upgrade: Web, TFTP, FTP
 Reset to the factory defaults
 DNS relay
 Virtual server
 DMZ
 Two-level passwords and user names
 Web user interface
 Telnet CLI
 System status display
 PPP session PAP and CHAP
 IP filter
 IP QoS
 Remote access control
 Line connection status test
 Remote management (telnet and HTTP)
 Backup and restoration of configuration file
 Ethernet interface supports crossover detection, auto-correction and
polarity correction
 UPnP
 IPV6
 3G WAN and 3G Backup
 Samba for USB storage

D-Link DSL-2750E Specifications

ADSL Standards

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite ADSL downstream	up to 1.5 Mbps
G.lite ADSL upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 12 Mbps
ADSL full rate downstream	up to 24 Mbps
ADSL full rate upstream	up to 1 Mbps

Media Interface

ADSL interface	RJ-11 connector for connection to 24/26 AWG twisted pair telephone line
LAN interface	RJ-45 port for 10/100BASE-T Ethernet connection