DSL-522T ADSL Router User Guide
Rear Panel Connections
All cable connections to the Router are made at the rear panel. Connect the power adapter here to power on
the Router. Use the Reset button to restore the settings to the factory default values in the next chapter for
instructions on using the reset button).
Connect network cables:
1. Insert the ADSL (telephone) cable included with the Router into the ADSL port and then connect the
cable to your telephone line.
2. Insert one end of the Ethernet cable into the Ethernet (LAN) port on the back panel of the Router and
the other end of the cable to an Ethernet Adapter or available Ethernet port on your computer.
ADSL Port
Use the ADSL cable to
connect to the your telephone
line (RJ-11 port)
Ethernet Port
Use the Ethernet port
to connect the Router
to your Ethernet LAN
or computer
USB Port
Connect USB cable here
and install USB driver
Reset Button
To manually reset, depress
button with the power on
for at least seven seconds
Power Insert
Use the adapter
shipped with the
Router to connect to
power source
4
To Next Page
Loading...
Need help?
General
