D-Link EasySmart Switch User Manual
18
Figure 6– SmartConsole Delete device
Device List
This list displays all discovered Web Smart and EasySmart switches on the network.
Figure 32– SmartConsole Device List
Definitions of the Device List features:
Monitor: The
in the monitor means the device was discovered by SmartConsole. Click the icon to have
the device keep updating the information, The icon will become
. When the device was detected as not
reachable, the icon will change to
. Please check if the power or the cable of this device is disconnected.
Product Name: Displays the device product name.
IP Address: Displays the current IP addresses of devices.
Subnet Mask: Displays the Subnet Mask setting of the device.
Gateway: Displays the Gateway setting of the device.
MAC Address: Displays the device MAC Addresses.
Firmware version: Displays the current Firmware version of this device.
System Name: Displays the appointed device system name.
Location: Displays where the appointed device location.
SNMP: Displays the SNMP status of the device. This is not available for EasySmart switches.
Trap IP: Displays the IP address of host where the Trap information will be sent to.
DHCP: Specify if the device gets the IP address from a DHCP server.
Group Interval: Displays the intervals (in seconds). This feature is not available for EasySmart switches.
NOTE: If the devices are marked red in the device
list, it means that the devices require upgrading
firmware again.
To Next Page
Loading...
Need help?
General
