Power Train Specifications
Final Drive
(1) Apply Loctite No.242 Thread Lock to thread of
bolt (1) and tighten to a torque of
........................................................115 L 14 N¥m
(2) Torque for wheel mounting bolts (2)
..............................270 L 25 N¥m (200 L 18 lb¥ft)
(3) Torque for bolts (3) holding service brake
....................................55 L 10 N¥m (41 L 7 lb¥ft)
(4) Heat retainer (4) to a temperature of 371 to
427¡C (700 to 801¡F) for no more than four hours
and install on axle shaft.
32
To Next Page
Loading...
Need help?
General
