Cable holder
Cover Bottom
(except DLT-42G1 model)
- When you install on a wall mounting you can fit
cover bottom as shown in upper picture.
The method of wire arrangement
1. Assemble the cable holder enclosed on the back
of TV.
(PICTURE1)
(ASSEMBLY METHOD: After you push the (peg
part of cable holder) „A” in the hole, rotate the
cable holder clockwise at an angle of 90°. You
can separate in reverse order of assembly.)
2. Open the cable holder. (PICTURE 2)
( you can open the cable holder by pressing and
pushing „B” part.)
3. After arranging the leads with the cable holder,
lock „B” again. (PICTURE 3)
Remote control Batteries
A
B