Daewoo DTC-410 User Manual

DTC-410
24
? Receive only
+ Check if P/T mode is properly set, reset the dialing mode accordingly.
? Noise
+ Check if the circuit is spoilt, change the circuit.
Check if the connector is wet or rusty, change the connector.
? Ring once then disconnect when receiving a call. Dialing function is still available
+ Check if connector is in a moist environment.
Check if too many extensions are used together or the quality of extension is not good enough, change
the bad extension.
? LCD become dim
+ Check if LCD contrast is properly set or if the batteries are weak, adjust LCD contrast, if the LCD is still dim,
replace the batteries.
? No ring
+ Check if the RING switch is in the OFF position, reset it.
? Most of the functions failed
+ Check if the batteries are strong enough, change the batteries.
If batteries are ok, remove the battery, unplug the lines and reinstall after 10 minutes.
STATEMENT OF COMPLIANCE
Flamagas S.A. hereby declares that the DTC-410 product complies with the requisites and basic safety
requirements of Directive 1999/5/EC on Radio and Telecommunications Terminal Equipment.
For a full copy of the statement of compliance please see:
www.electronicaflamagas.com

Daewoo DTC-410 Specifications

General

Brand	Daewoo
Model	DTC-410
Category	Telephone
Language	English