11
Chapter 3 :
Operating Your TV
Operating Your TV
Once you have connected your TV to an antenna or cable system, plugged the TV in, and put batter-
ies in the remote, you are ready to use the TV. The first thing you should do is program your TV so
it memorizes all of available channels.
Turning Your TV On
1
To turn your TV on, press the POWER button on the remote control. You
can also use the POWER button on the front panel. Make sure your TV is
plugged in before you try to turn it on.
Programming Your TV's Channel Memory
Your TV's memory determines the channels that are available using the VCHW buttons. If a chan-
nel is not in memory, you can tune to it with the number buttons, but not with the VCHW buttons.
Follow these steps to program your TV's memory:
1
With the TV on, press the MENU button twice, then “Set-Up”menu will appear.
2
Use the VCHW buttons to select “Reception”, then use the CVOLB buttons to select ‘Air’ or
‘Cable’. If you connected an antenna to your TV, select ‘Air’; If you connected a cable system,
select ‘Cable’.
3
Use the VCHW buttons to select “Memorize Channels”, then use the CVOLB buttons to enter
the “Memorize Channels” process. Again press the CVOLB buttons to begin.
4
Press the MENU button to return to Set-Up menu.
5
Press the MENU button three times to return to normal TV viewing.
Your TV's channel memory will not be affected by a power outage. You will not need to re-program
the memory unless you change the type of cable or antenna connected to your TV.
To Next Page
Loading...
Need help?
General