10
INSTALLATION
FOR ORDINARY TAP
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washer by
turning it clockwise to be fixed
tightly.
• Please check the rubber
packing present inside the inlet
hose adapter of the hose.
1 Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
2 Loosen the four
screws properly in
order to fit into
water tap.
4 Remove the tape,
and screw connector
B into connector A
tightly.
5 Connect the inlet
hose to the water tap
adapter by pulling
down the collar of the
hose end.
3 Fit the water tap adapter into
the water tap and tighten the
four screws evenly while
pushing up the adapter so that
the
rubber packing can stick to the
water tap tightly.
■ Connecting inlet hose
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
FOR SCREW-SHAPED TAP
3
Connect the inlet hose adapter
to the water inlet of the washer
and turn it to be fixed.
• Check the packing in the inlet.
1 Connect the inlet hose
to the water tap
adapter by pulling
down the collar of the
hose end.
2
Connect the
connector- inlet
supplied if
necessary.
To Next Page
Loading...
Need help?
General