22
8. FUNCTION OF THE CONVENIENT SERVICE
FUNCTION OF THE CONVENIENT SERVICE
■ The test mode of the load movement
You can check the PCB ASS'Y and the condition of each load movement simply.
• The method to test the load movement
1 Plug the power cord.
2 Turn the program selector to arbitrary program (except for OFF position).
(The indicator light of the Start/Hold button is on but not twinkles. If the indicator is twinkles, press the
Start/Hold button and turn the program selector to the off.)
3 Press the Rinse+ button 3times while press the Rinse Hold button.
4 Whenever the Time Delay button is pressed, each load movement is occurred as follows;
Door lock close → Hot valve on → Cold valve on → Pre wash valve on → Bubble pump on → Drain pump on
To Next Page
Loading...
Need help?
General