4
Before installing your washer, remove the
pad from the bottom of the cabinet.
Then, separate under cover from rear side
of cabinet by unscrewing and insert it into
the base.
Push the under-base cover into the end,
which decrease the noise made by this
washer.
Installation of the Under Base Cover (Option)
-DWF-5510/5511/6010/6011
Location
Place your washer on a level and solid floor,
considering the length of inlet hose, drain
hose and power supply cord.
Do not place or store your washer below 0°C(32°F) to avoid
any damage from freezing.
Do not place your washer where it may be splashed during
bathing.
If washer is not level, it should be corrected
by the adjustable leg (provided optionally) in
the front-right side under the base and/or, a
thin block or brick.
DIRECTIONS FOR SAFE USE
After the packing box is opened, there is
a under-base cover at the top of
the washer.
Push the under-base cover into the end,
which decrease the noise made by this
washer.
-DWF-5520/5521/6020/6021
å∫
After installing the washing machine, assemble
the under-base cover.
NOTES:
The opening muse not be obstructed by carpeting when
the washing machine is installed on a carpeted floor.
To Next Page
Loading...
Need help?
General
