1
Insert a screw driver (flat tip) into a groove of the right wheel (bottom of refrigerator) and
turn it clockwise until the door is balanced. (clockwise to raise refrigerator door ;
counterclockwise to lower)
Unless the refrigerator door is balanced by step 1, then follow the next steps.
2
Loosen 3 hinge bolts(2 on the left + 1 on the right) a little. (Do not unfasten them
completely.)
Insert a hexagonal wrench into the groove of adjusting nut and turn clockwise until the
door is level.
3
Once the door is balanced, fasten the hinge bolts tightly.
In case refrigerator door is lower than freezer door...
Hinge Bolt
After installation and/or door leveling, fasten front cover with screws.(Remove the screws on the front bottom panel first.
Click and screw the cover)
Front Cover
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
1
Insert a screw driver (flat tip) into a groove of the left wheel (bottom of freezer) and turn it
clockwise until the door is balanced. (clockwise to raise freezer door ; counterclockwise
to lower)
Unless the freezer door is balanced by step 1, then follow the next steps.
2
Open the doors, unscrew the front cover and remove, if it is attached.
3
Loosen 3 hinge bolts(1 on the left + 2 on the right) a little. (Do not unfasten them
completely.) Insert a hexagonal wrench into the groove of adjusting nut and turn
clockwise until the door is level.
4
Once the door is balanced, fasten the hinge bolts tightly and screw the front cover.
In case freezer door is lower than refrigerator door...
The front of refrigerator needs to be higher just a little than the back for easy door
closing, but if the wheel is raised too much for door balance, i.e. front of refrigerator
is too higher than the back, it can be difficult to open the door.
Hinge Bolt
To Next Page
Loading...
Need help?
General
