16
(1) Remove the gasket door ¤ from door plate.
(2) Remove the barrier screen inner ¤Łfrom door plate.
(3) Remove the door frame ¤Øfrom door plate.
(4) Remove the spring ¤ºand the hook ¤Œ.
(5) Remove the barrier screen outer ¤ from door frame ¤Ø.
(6) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’
1) Loosen two screws on stopper hinge top, and
then push the door to contact the door seal to
oven front surface.
2) Tighten two screws.
(2) To reduce gap located on part ‘B’.
1) Loosen three screws on bottom hinge, and then the door to contact the door seal to oven front surface.
2) Tighten three screws.
(3) To reduce gap locatated on part ‘C’. (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
3) Tighten a screw.
(4) To reduce gap located on part ‘D’. (See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step (3) 2) and 3).
To Next Page
Loading...
Need help?
General
