3 Network Configuration
The IP address of all the cameras is the same when leaving factory (default IP 192.168.1.108).
To make the camera access to the network smoothly, please plan the available IP segment
reasonably according to the actual network environment.
3.1 Modify IP Address
The cameras which are accessed via wired network can acquire and modify the IP address
through "Quick Configuration Tool". This section introduces the approach of modifying IP address
via "Quick Configuration Tool". You can also modify the IP address in the network parameters of
the WEB interface. Please refer to the document WEB Operation Manual in the disk for more
details.
To modify IP address, do the following:
Step 1
Double-click "ConfigTool.exe" to open the "Quick Configuration Tool".
Step 2
Click to enter the interface where you can modify IP address, and then click Search
setting.
The system pops up the Setting dialog box, see Figure 3-1.
Figure 3-1
Step 3
Set the device network segment, login user name and password, and then click OK. The system
will display the searched devices after searching completes.
Note
The default username and password is admin and admin respectively.
Step 4
Select the devices which IP addresses need to be modified, and then click .
The system will pop up the Modify IP Address dialog box, see Figure 3-2.
To Next Page
Loading...
Need help?
General
