31
Setting the Vacation Timer
The vacation timer lets you set the date and time of your RETURN from vacation. Until that date/time, the system will remain at
the VACATION heating and cooling setpoints specified in the configuration menu.
To use the EASY VACATION feature:
Press , then press the to scroll to “Vacation” then press again. The thermostat will automatically go into Vacation
mode with the default return date 1 month later .
To set the vacation timer (and begin vacation setpoint mode): 1. Press to select operating mode.
2. Press , then press until VACATION appears. 3.Press to enter date and time you plan to RETURN from vacation.
4. When your finished entering the date/time, press .
Schedule Override
The schedule override feature allows the user to override the program schedule for 1 to 5 hours. In addition, if selected, the
schedule can be overridden only until the next transition period.
To access the Schedule override feature, enter the screen, then use to scroll through the menu options until you reach
the SCHEDULE OVERRIDE screen. In the default setting, the Vacation & Schedule periods will be flashing in the upper right
corner of the LCD. In this mode, the Vacation & Schedule will be overridden until the next transition period. To switch to the 1-5
hour override, use the arrow. This mode allows the user to override the Schedule set points for 1-5 hours.
Alarm Reset
This thermostat is equipped with unit fault reset capabilities when used with the Michrotech III WSHP unit controller.
If the water source heat pump enters a fault mode, the alarm icon will illuminate on the thermostat. When the condition has
been corrected, the unit can be reset from the thermostat.
1. Press the
2. press the CONFIG repeatedly until the alarm reset appears
3. Press the arrow to change the display to Y, then press
To Next Page
Loading...
Need help?
General
