10
User's manual
EN
The “All the zones” option allows you to control all the zones at the same time, communicating the
changes to all of them.
Press the name of a zone to control it remotely from the thermostat. When the system detects a
temperature error in a specic zone, the zone displays the error code instead of the room temperature (see
Incidents
section).
Remote zone
navigation icons:
Return to the zone navigation list.
Return to the main screen.
User settings
Units. Select Celsius or Fahrenheit degrees.
Language. Select the language.
Brightness. Adjust the brightness, and enable or disable the screen brightness when the
screen saver is active.
Information. This parameter provides information on:
• Zone: rmware, zone, association, actuator or status of the communications.
• System: rmware, settings and information about the system controllers.
• Devices: It displays the elements connected to the system.
• Webserver: conguration, association, IP Direction and MAC. This parameter may or may not appear
depending on your kind of installation.
• Errors.
To Next Page
Loading...
Need help?
General
