■English 5
■
Outdoor Unit
■ Indoor Unit
1. Air filter
2. Air-purifying filter with photocatalytic
deodorizing function:
• These filters are attached to the inside of the
air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. INTELLIGENT EYE sensor:
•
It detects the movements of people and
automatically switches between normal operation
and energy saving operation. (page 18.)
7. Display
8. Air outlet
9. Flaps (horizontal blades): (page 12.)
10. Louvers (vertical blades):
•
The louvers are inside of the air outlet. (page 13.)
11. Operation lamp (green)
12. TIMER lamp (yellow): (page 20.)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation. (page 16.)
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
•
The operation mode refers to the following table.
• This switch is useful when the remote
controller is missing.
15. Packaging materials:
• If any packaging materials are included,
please remove before operating. (page 24.)
16. Room temperature sensor:
• It senses the air temperature around the unit.
17. Signal receiver:
• It receives signals from the remote controller.
•
When the unit receives a signal, you will hear a
short beep.
• Operation start .........beep-beep
• Settings changed ......beep
• Operation stop ..........beeeeep
■ Outdoor Unit
18. Air inlet: (Back and side)
19. Air outlet
20. Refrigerant piping and inter-unit cable
21. Drain hose
22.
Grounding terminal:
• It is inside of this cover.
Appearance of the outdoor unit may differ from some models.
'
&
Mode
Temperature
setting
Airflow rate
AUTO 77°FAUTO
01_EN_3P194537-2B.fm Page 5 Monday, July 2, 2007 5:19 PM
To Next Page
Loading...
Need help?
General
