Danfoss 103E5 User Manual

6
103, 103E5
Wiring
Wiring
10. Then press the SELECT button until the bar lines up with
the word OFF and check the system does not operate.
11. When the circuit check has been completed, replace the
wiring cover and tighten the xing screw. Cut any cable
aperture in the wiring cover which may be necessary to
accommodate surface mounted cables.
12. Finally set time of day and programmes required, noting
that the unit is supplied with a pre-set programme, as
stated on Page 14.

Danfoss 103E5 Specifications

General

Brand	Danfoss
Model	103E5
Category	Thermostat
Language	English