Danfoss DHP-L Installation Guide

N
If the sensor cable is connected through a pipe, the pipe must be sealed so that the sensor is not affected by
outgoing air.
1. Position the outdoor sensor on the north or north west side of the house.
2. Connect the sensor to the heat pump’s control system.
6.5 Connect outdoor unit
Caution The power cable may only be connected to the terminal block intended for this purpose. No other terminal
blocks may be used!
Outdoor unit Heat pump
N/220
211
213
104
218
386
387
125
N/220
126
N/220
127
PE
220/N
211
213
283
104
218
386
387
125
4
5
7
8
1
2
3
6
1 Neutral
2 Fan high speed
3 Fan low speed
4 Motor protection fan
5 Defrost sensor
6 Accessories
7 Heating, drip tray
8 Heating cable
1. Route the power cable through the opening in the top panel of the heat pump to the terminal blocks.
2. Connect the power cable to the terminal block.
6.6
Connect temperature sensor hot water
Sensor for hot water and hot water peak from external water heater is connected in the following way to DHP-L.
311
312
325
326
54
55
54 Hot water sensor
55 Hot water top sensor
Installation Guide Domestic heat pumps
Danfoss Heating Solutions VMGFQ102
35

Danfoss DHP-L Specifications

General

Brand	Danfoss
Model	DHP-L
Category	Heat Pump
Language	English