1.8 Pairing Danfoss Eco™
Note, Turn on Bluetooth on your smart phone to connect to the Danfoss Eco™.
Follow the prompts from the Danfoss Eco™ App to pair your Danfoss Eco™.
Bluetooth range is 10m (depending on the building construction and surroundings).
1.9 Automatic adjustments
When Danfoss Eco™ is installed it will automatically begin to adjust itself to your heating system,
during the first week after insallation. During this process you might experience that the ther-
mostat reacts slowly or turns the heat up and down by itself. This is normal and a necessary part
of the adjustment process.
1. Adjusting to the valve
During the first night of operation Danfoss Eco™ will shut off the radiator heat and then open
again to detect the exact opening point of the valve. This will allow Danfoss Eco™ to control the
heat as efficiently as possible. If necessary, the procedure is repeated once a night for up to a
week.
2. Adaptive Learning
If you activate Adaptive Learning Danfoss Eco™ learns during the first week of operation when
it is necessary to start heating the room in order to reach the correct temperature at the correct
time.
The intelligent control will continuously adjust the heating time compared to seasonal tempera-
ture changes.
Using Saving Program requires that your heating system has enough heat for a short period
during heat up. If you experience problems you should contact your installer.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
