Danfoss EKC 223 User Manual

Figure 2: System interfaces of EKC 223/224
MPK
EKC 223, 224
System Manager
KoolKey
KoolProg
Danfoss 80G8445
SET
V
V
V
RS-485 adapter (EKA 206)
The RS-485 adapter (EKA 206) adapter allows to integrate the controller on a Modbus eldbus. The controller is
supported by the following Danfoss front ends:
• AK-SM 720 system manager
• AK-SM 800 system manager
• AK-SM 800A system manager
The KoolKey (EKA 200) allows to connect the EKC controllers to the PC application named “KoolProg”. Via KoolProg it
is possible to perform on-line and o-line programming of the EKC controllers. It can also perform production line
programming of multiple controllers and show on-line trend curves on selected parameters.
Finally “KoolProg” can also load controller setup les into the MPK - Mass Programming Key (EKA 201) which can be
used for simple production line programming of EKC controllers.
Please refer to the KoolProg
®
User Guide for detailed instructions on how to use KoolProg
®
. Download KoolProg
®
at:
http://koolprog.danfoss.com. Refer to the installation guides of KoolKey (EKA 200) and Mass Programming Key (EKA
201) for further details on how to interface and use these modules.
Case controller, type EKC 223 and EKC 224
© Danfoss | Climate Solutions | 2023.05 BC432222569027en-000201 | 6

Danfoss EKC 223 Specifications

General

Brand	Danfoss
Model	EKC 223
Category	Controller
Language	English