Danfoss RX1-S V2 User Manual

AN30483496955101-000102 RX1-S V2 5
8. Mount back plate direct to wall or on a wall box. The
back plate included within the product packaging
must be used for installation.
9. Locate hooks at top of front part into top of back plate
and lower into position and tighten retaining screw.
2. Dimensions and Wiring
See g. 4 for dimensions and g. 5 for wiring diagram on
page 45.
3.1 RF Pairing
1. Ensure power to RX1-S V2 receiver is switched on and
batteries are inserted into thermostat.
2. Put the thermostat in pairing mode, see thermostat
installation guide.
3. Press both PROG and CH buttons on RX1-S V2 until
button LEDs ash.
4. If pairing is successful RF icon on thermostat will stop
ashing and remain on.
5. If pairing is not successful try moving thermostat
toalternative position and retry.
Installation Guide
EN

Danfoss RX1-S V2 Specifications

General

Brand	Danfoss
Model	RX1-S V2
Category	Receiver
Language	English