15
Please Note
The unit must be programmed in sequence and EVENT times
cannot be programmed out of sequence.
The event 1 time setting can be set at any time of day (normally
in the morning). The time settings for events 2 to 6 can only be
placed between the previous setting and 1.59.
If you want to leave a preset time as it is, simply press PROG to
move on to the next setting.
During programming, if no buttons are pressed for 2 to 3
minutes the unit will automatically return to RUN mode, and the
programme set up to that minute will be active.
If at any time you get confused and need to reset the unit to the
preset programmes, press and hold the + , – , & buttons at
the same time.
Before you change the preset programmes
!
User Instructions
GB
To Next Page
Loading...
Need help?
General
