9
GB - User Instructions
The unit is now in RUN mode (colon
fl ashes in display) and the heating
will operate according to the preset
programmes.
a) Press PROG until Event 1
fl ashes, then press DAY to move from
current day to Day 1.
b) Amend the time and temperature
as follows:
i) Use + and – buttons to
alter time (press and hold to
change in 10 min increments).
ii) Use and buttons to alter
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to
next Event
iv) Repeat steps i,ii & iii above for
Events 2, 3, 4, 5 & 6
Programming in 7-day mode
(separate programmes for each day of the week)
1
Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day
mode or 5/2 day mode. To tell which mode your unit is set
press PROG until Event 1 fl ashes in the display.
This unit is in 7-day mode and you can
programme different settings for each day of the
week (see page 9-10).
This unit is in 5/2 day mode and you can enter
one of set of programmes for weekdays and
another set for weekends (see page 10).
1
1 2 3 4 5
To Next Page
Loading...
Need help?
General
