To Next Page

To Previous Page

TS715SI

Speciﬁ cation 230V model 24V model

Power supply

230 Vac,

±15%,

50/60 Hz

24 Vac,

±15%,

50/60 Hz

Switching action

1 x SPDT voltage free, Type 1B

Switch rating 24-230 Vac, 3(1)A

Battery back-up 24 hours minimum

Setting/Running Accuracy ± 1 minute

Dimensions, mm (W, H, D) 135 x 88 x 32

Design standard EN 60730-2-7

Control Pollution Situation Degree 2

Rated Impulse Voltage 2.5 kV

Ball Pressure Test 75°C

• Remove wallplate from unit by unscrewing the two screws on the

bottom edge of the unit.

• From the top left hand corner of the wallplate, there must be

clearances of at least 140 mm to the right, 15mm to the left,

30mm above and 100mm below in order to mount the plug-on

module.

1.0 Installation Overview

2.0 Product Speciﬁ cation

Please Note:

This product should only be installed by a qualiﬁ ed electrician or

competent heating installer and should be in accordance with the

current edition of the IEEE wiring regulations.

3.0 Installation

Danfoss TS715Si Installation Guide

Other manuals for Danfoss TS715Si