MG.20.B6.02 – VLT is a registered Danfoss trademark
VLT
®
2000 Series
102
Your parameter settings
We recommend you to write down the settings of the
various parameters in the forms on the following
pa-pa-
pa-pa-
pa-
gege
gege
ges.
You can write down the settings for each of the two
setups, which can be programmed in parameter 001.
Filled-in forms will give you a quick survey of how your
VLT frequency converter is set.
X = factory settings
Factory settings and service
Setup 1 Setup 2
000 LANGUAGE X ENGLISH
GERMAN
FRENCH
DANISH
001 MENU SETUP X SETUP 1
SETUP 2
MULTI SETUP
002 MENU SET COPY X DO NOT COPY
COPY 1 TO 2
COPY 2 TO 1
FACTORY TO 1
FACTORY TO 2
003 LOCAL REMOTE X REMOTE
LOC EXT.STOP
LOCAL+REMOTE
004 LOCAL SPEED HZ
005 VALUE AT MAX
006 LOCAL RESET DISABLE
X ENABLE
007 LOC START/STOP DISABLE
X ENABLE
008 LOCAL FWD/REV X DISABLE
ENABLE
009 LOCAL JOG DISABLE
X ENABLE
010 LOCAL DISABLE
REFERENCE X ENABLE
013 DATA CHG. LOCK X NOT LOCKED
LOCKED
101 SPEED CONTROL OPEN LOOP
X X SLIP COMP.
CLOSED LOOP
102 CURRENT LIMIT X PROGRAM SET
10 VDC SIGNAL
20 mA SIGNAL
Setup 1 Setup 2
103 MOTOR POWER UNDER SIZE
X X NOM. SIZE
OVER SIZE
104 MOTOR VOLTAGE 200 V
208 V
X X 220 V
230 V
240 V
380 V
X X 400 V
415 V
440 V
460 V
105 MOTOR FREQ. X X 50 HZ
60 HZ
87 HZ
100 HZ
107 MOTOR CURRENT A
108 MOTOR MAG. AMP. A
■
To Next Page
Loading...
Need help?
General