Danfoss VLT 2800 Series General Information

NOTE
Please note that parameter 020 may block
the choice of mode.
Warnings/alarms
Warnings or alarms appear in the LED display as a
numerical code [Err. xx]. A warning is displayed until
the fault has been corrected, while an alarm will flash
until the [STOP/RESET] key is pressed. The table in
Warnings/alarms messages in this manual explains the
various warnings and alarms, and whether a fault locks
the adjustable frequency drive. After a Trip locked
fault, cut off the AC line supply and correct the fault.
Then reconnect the AC line supply and press the
[STOP/RESET] key. The adjustable frequency drive is
now reset and ready. See Warnings/alarms messages
in this manual for more detail.
VLT
®
2800 Series
30 MG.27.A2.22 - VLT
®
is a registered Danfoss trademark

Danfoss VLT 2800 Series Specifications

General

Brand	Danfoss
Model	VLT 2800 Series
Category	DC Drives
Language	English