VLT
®
3000 to 5000 Converter
MG.50.Q2.02 – VLT is a registered Danfoss trade mark6
Mapping list
LT 3000 Series
LT 5000 series
200 Frequency Range 200 Output Frequency Range/Direction
201 Min. Frequency 201 Output Frequency Low Limit
203 Jog frequency 213 Jog frequency
204 Digital Reference Type 214 Reference Function
205 Digital Reference 1 215 Preset Reference 1
206 Digital Reference 2 216 Preset Reference 2
207 Digital Reference 3 217 Preset Reference 3
208 Digital Reference 4 218 Preset Reference 4
209 Current Limit
orque
m
t
n
otor
o
e
Parameter 222, Torque limit in Generating
Operation, is set to the same value as parameter
221.
210 Warning Frequency Low 225 Warning: Low Frequency
211 Warning Frequency High 226 Warning: High Frequency
212 Warning Current Low 223 Warning: Low Current
213 Warning Current High, 224 Warning: High Current
214 Ramp type 206 Ramp type
215 Ramp-Up Time 207 Ramp-Up Time 1
216 Ramp-Down Time 208 Ramp-Down Time 1
217 Alternative Ramp-Up Time 209 Ramp-Up Time 2
218 Alternative Ramp-Down Time 210 Ramp-Down Time 2
219 Frequency bypass 1 230 Frequency bypass 1
220 Frequency bypass 2 231 Frequency bypass 2
221 Frequency bypass 3 232 Frequency bypass 3
222 Frequency bypass 4 233 Frequency bypass 4
223 Frequency bypass, bandwidth 229 Frequency bypass, bandwidth
224 Carrier Frequency 411 Switching Frequency
225 Output Frequency Dependant Switch
Frequency
412 Output Frequency Dependant Switching
Frequency
231 Brake Cut-In Frequency 225 Warning: Low Frequency.
This parameter is used for setting the level for
general warnings at too low frequencies. In
combination selection of "Mechanical Brake
Control" in parameter 323 and 326 the functionality
of this parameter is control of the cut-in frequency
232 Current, Minimum Value 223 Warning: Low Current
233 Current, Delay Time 120 Start Delay Time
Mapping list