Danfoss VLT 3000 Series Introduction Guide

7
MG.50.Q2.02 – VLT is a registered Danfoss trade mark
VLT
®
3000 to 5000 converter
V
LT 3000 Series
V
LT 5000 series
300 Brake Option 400 Brake Function
301 Start frequency 130 Start frequency
302 Start delay 120 Start delay
303 High starting torque 119 High starting torque
304 Mains failure 407 Mains failure
305 Flying start 445 Flying start
306 DC braking time 126 DC braking time
307 DC Brake Cut-in Frequency at Stop
127 DC Brake Cut-in Fre
q
uenc
y
309 Reset Mode 405 Reset Function
310 Trip Delay at Current Limit
409 Trip Delay Torque
Note VLT 5000 is using a Torque limit and not a
Current limit.
311 Trip Delay at Inverter Fault 410 Trip Delay Inverter
312 Max. Auto Restart Time 406 Automatic Restart Time
313 Motor Chec
k
122 Function at Stop
314 Motor Preheat 122 Function at Stop
315 Motor thermal protection 128 Motor thermal protection
316 Relay ON-delay 324 Relay 01 ON-delay
317 Relay OFF-delay 325 Relay 01 OFF-delay
400 Binary Input 16 300 Terminal 16 Input
401Binary Input 17 301 Terminal 17 Input
402 Binary Input 18 302 Terminal 18 Input
403 Binary Input 19 303 Terminal 19 Input
404 Binary Input 27 304 Terminal 27 Input
405 Binary Input 29 305 Terminal 29 Input
406 Binary Input 32 306, 307 Terminal 32/33 Input
407 Signal Output 42 319 Terminal 42 Output
408 Signal Output 45 321 Terminal 45 Output
409 Relay output 01 323 Relay output 01
410 Relay output 04 326 Relay output 04
411 Analog reference type 203, 204, 205 Reference scaling
412 Term. 53 Analog input Voltage 309, 310 Analog input 53 scaling
413 Term. 60 Analog input mA 315, 316 Analog input 60 scaling
414 Time out 317 Time out
415 Time Out Function 318 Function after Time Out
Mapping list

Danfoss VLT 3000 Series Specifications

General

Brand	Danfoss
Model	VLT 3000 Series
Category	Media Converter
Language	English