Danfoss VLT CANopen MCA 105 Operating Instructions

3.2 Mechanical Installation
Preparation of the mechanical installation of the frequency
converter must be done carefully to ensure a proper result
and to avoid additional work during installation. Start
taking a close look at the mechanical drawings at the end
of this instruction to become familiar with the space
demands.
3.2.1 Tools Needed
To perform the mechanical installation the following
tools are needed:
•
Drill with 10 or 12 mm drill
•
Tape measure
•
Wrench with relevant metric sockets (7-17mm)
•
Extensions to wrench
•
Sheet metal punch for conduits or cable glands
in IP21/Nema 1 and IP54 units
•
Lifting bar to lift the unit (rod or tube max. Ø 5
mm (1 inch), able to lift minimum 400 kg (880
lbs)).
•
Crane or other lifting aid to place the frequency
converter in position
•
A Torx T50 tool is needed to install the E1 in IP21
and IP54 enclosure types.
3.2.2
General Considerations
Wire access
Ensure that proper cable access is present including
necessary bending allowance. As the IP00 enclosure is
open to the bottom cables must be fixed to the back
panel of the enclosure where the frequency converter is
mounted, i.e. by using cable clamps.
CAUTION
All cable lugs/shoes must mount within the width of the
terminal bus bar.
Space
Ensure proper space above and below the frequency
converter to allow airflow and cable access. In addition
space in front of the unit must be considered to enable
opening of the door of the panel.
176FA235.11
<105,0°
526
(20.7)
399
(15.7)
Illustration 3.9 Space in Front of IP21/IP54 Rated Enclosure
Types D1 and D2
748
(29.5)
579
(22.8)
176FA276.12
≤105,0°
Illustration 3.10 Space in Front of IP21/IP54 Rated Enclosure
Type E1
130BB003.13
578
(22.8)
776
(30.6)
Illustration 3.11 Space in Front of IP21/IP54 Rated Enclosure
Type F1
2X578
[22.8]
776
[30.6]
130BB004.13
Illustration 3.12 Space in Front of IP21/IP54 Rated Enclosure
Type F3
130BB005.13
624
[24.6]
579
[22.8]
578
[22.8]
Illustration 3.13 Space in Front of IP21/IP54 Rated Enclosure
Type F2
How to Install
VLT
®
Automation Drive FC 300 Operating Instructions
MG33U402 - Rev. 2013-12-16 19
3 3

Danfoss VLT CANopen MCA 105 Specifications

General

Brand	Danfoss
Model	VLT CANopen MCA 105
Category	DC Drives
Language	English