Danfoss VLT FC 300 Operating Instructions

1 How to Read these Operating Instructions
The frequency converter is designed to provide high shaft
performance on electrical motors. Please read this manual
carefully for proper use. Incorrect handling of the
frequency converter may cause improper operation of the
frequency converter or related equipment, shorten lifetime
or cause other troubles.
These Operating Instructions will help you get started,
install, program, and troubleshoot your frequency
converter.
Chapter 1, How to Read these Operating Instructions,
introduces the manual and informs you about the
approvals, symbols, and abbreviations used in this
literature.
Chapter 2, Safety Instructions and General Warnings,
entails instructions on how to handle the frequency
converter correctly.
Chapter 3, How to Install, guides through mechanical and
technical installation.
Chapter 4, How to Programme, shows how to operate and
programme the frequency converter via the LCP.
Chapter 5, General Specifications, contains technical data
about the frequency converter.
Chapter 6, Warnings and Alarms, assists in solving
problems that may occur when using the frequency
converter.
Available literature
-
The VLT AutomationDrive Operating Instructions -
High Power, MG33UXYY provide the necessary
information for getting the frequency converter
up and running.
-
The VLT AutomationDrive Design Guide MG33BXYY
entails all technical information about the
frequency converter and customer design and
applications.
-
The VLT AutomationDrive Programming Guide
MG33MXYY provides information on how to
programme and includes complete parameter
descriptions.
-
The VLT AutomationDrive Profibus Operating
Instructions MG33CXYY provide the information
required for controlling, monitoring and
programming the frequency converter via a
Profibus fieldbus.
-
The VLT AutomationDrive DeviceNet Operating
Instructions MG33DXYY provide the information
required for controlling, monitoring and
programming the frequency converter via a
DeviceNet fieldbus.
X = Revision number
YY = Language code
Danfoss technical literature is also available online at
www.danfoss.com/drives.
Symbols
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operate equipment at
less than optimal performance.
Approvals
1.1.1
Disposal Instruction
Equipment containing electrical
components may not be disposed of
together with domestic waste.
It must be separately collected with
electrical and electronic waste according
to local and currently valid legislation.
How to Read these Operating...
VLT
®
Automation Drive FC 300 12-Pulse
Operating Instructions High Power
MG34Q202 - VLT
®
is a registered Danfoss trademark 3
1 1

Danfoss VLT FC 300 Specifications

General

Brand	Danfoss
Model	VLT FC 300
Category	DC Drives
Language	English