Dantherm HPP-iw Series User Manual

20
1007332 ISSUE 1
OWNER/INSTALLATION MANUAL
3�10 INSTALLING THE OPTIONAL REMOTE CONTROLLER
This optional accessory replaces e integral controller
and can be installed up to 10m away.
Take e lid off e HPP-i to gain access to e existing
controller. Remove e front cover. Disconnect e plug
from e socket on e back of e controller as shown.
Remove e bulkhead connector from e position
shown and replace it wi a rubber grommet.
This hole
Feed e 10m cable rough e grommet.
Route e cable inside e HPP-i securing it where
necessary.

Dantherm HPP-iw Series Specifications

General

Brand	Dantherm
Model	HPP-iw Series
Category	Heat Pump
Language	English