Pick Mode
12 PowerScan™ PM9501
Motion Aiming Control
This feature configures the ability of the scanner to
Enable/Disable the Aiming system when motion is
detected (Motionix™ motion-sensing technology). Scan
the Enter/Exit Programming bar code above, then either
of the bar codes below.
Pick Mode
Pick Mode is a Decoding and Transmission process where
bar codes that are not within the configurable distance
from the center of the aiming pattern are not acknowl-
edged or transmitted to the host. It is active only in Trigger
Single mode. If the scanner switches to a different Read
Mode, Pick Mode is automatically disabled.
Motion Aiming Control =
Enable
Motion Aiming Control =
Disable
NOTE
This feature is not compatible with Multiple
Labels Reading in a Volume. See the PRG for
more information.
ENTER/EXIT PROGRAMMING MODE
PIck Mode = Disable
Pick Mode = Enable
To Next Page
Loading...
Need help?
General
