15
4 / CARING FOR AND CLEANING YOUR APPLIANCE
EN
It is recommended that you replace the two
catalytic side panels when their self-
degreasing capability is no longer effective.
Start by removing the wire shelf side
supports – see the “Removing wire shelf
supports” section).
Remove the two old catalytic side panels
and replace them with new ones.
REPLACING THE CATALYTIC SIDE PANELS
(catalytic oven model)
••
WWiirree sshheellff ssuuppppoorrttss wwiitthh cclliipp ssyysstteemm..
Push down on the upper part of the shelf
support to unclip it from the central support
(fig. 1). Tilt the support towards the inside of
the oven and lift gently upwards to
disengage it from the two holes at the
bottom (fig. 2).
To re-fit the shelf supports after cleaning,
follow the above steps in the reverse order.
fig.2
fig.1
fig.1
To Next Page
Loading...
Need help?
General
