DEEP SEA ELECTRONICS DSECONTROL DSE7320 User Manual

DSE Model 7000 Series Control & Instrumentation System Operators Manual
Part No. 057-074 7000 Series OPERATING MANUAL ISSUE 2 02/05/2008 ADM 55
6.3.3 ENGINE RUNNING
Once the engine is running, the Warm Up timer, if selected, begins, allowing the engine to stabilise before accepting
the load.
Load will be automatically transferred from the mains supply to the generator.
NOTE:-The load transfer signal remains inactive until the Oil Pressure has risen. This prevents
excessive wear on the engine.
In test mode, the set will continue to run on load until either:
• The stop button is pressed – The set will immediately stop
• The auto button is pressed. The set will observe all auto mode start requests and stopping timers
before beginning the Auto mode stopping sequence.

DEEP SEA ELECTRONICS DSECONTROL DSE7320 Specifications

General

Brand	DEEP SEA ELECTRONICS
Model	DSECONTROL DSE7320
Category	Control Unit
Language	English