Steps
1. Align the rib inside the left-hinge cap to the outer sides.
2. Push the left-hinge cap down until it clicks in place.
3. Align the rib inside the right-hinge cap to the outer sides.
4. Push the right-hinge cap down until it clicks in place.
Next steps
1. Install the display assembly.
2. Install the WLAN card.
3. Install the base cover.
4. Exit service mode.
5. Install the SD card.
6. Follow the procedure in after working inside your computer.
56
Removing and installing components
To Next Page
Loading...
Need help?
General