Removing and Installing Parts 91
7
Connect the power and hard drive cables to the drive.
8
Check all connectors to be certain that they are properly cabled and firmly seated.
9
Replace the computer cover (page 102).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
10
Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
NOTE: If you are adding a floppy drive, see ""Installing a Floppy Drive" on page 93."
Removing a Floppy Drive
1
Follow the procedures in "Before You Begin" on page 55.
2
Remove the computer cover (see page 60).
To Next Page
Loading...
Need help?
General