86 Removing and Installing Parts
6
Locate the correct guidance-slot for the Media Card Reader (slot 2) and align the shoulder screws with
the screw guides.
7
Slide the Media Card Reader into the bay until it clicks into place.
8
Connect the power and data cables to the back of the Media Card Reader.
9
Connect the data cable to the USB connector on the system board (see "System Board Components"
on page 63).
10
Replace the computer cover (see "Replacing the Computer Cover" on page 90).
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the
computer.
11
Connect your computer and devices to electrical outlets, and then turn them on.
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
1 Media Card Reader 2 slot verification number
1
2
To Next Page
Loading...
Need help?
General