Dell Inspiron 1720 User Manual

88 Setting Up and Using Networks
Setting Up a New WLAN Using a Wireless Router and a Broadband
Modem
1 Contact your Internet service provider (ISP) to obtain specific information
about the connection requirements for your broadband modem.
2 Ensure that you have wired Internet access through your broadband
modem before you attempt to set up a wireless Internet connection (see
"Connecting a Network or Broadband Modem Cable" on page 85).
3 Install any software required for your wireless router. Your wireless router
may have been shipped with installation media. Installation media usually
contains installation and troubleshooting information. Install the required
software according to the instructions provided by the router
manufacturer.
4 Shut down your computer and any other wireless-enabled computers in
the vicinity through the Windows Vista Start button .
5 Disconnect your broadband modem power cable from the electrical outlet.
6 Disconnect the network cable from the computer and the modem.
7 Disconnect the AC adapter cable from your wireless router to ensure that
there is no power connected to the router.
NOTE: Wait for a minimum of 5 minutes after disconnecting your broadband
modem before continuing with the network setup.
8 Insert a network cable into the network (RJ-45) connector on the
unpowered broadband modem.
9 Connect the other end of the network cable into the Internet network
(RJ-45) connector on the unpowered wireless router.
10 Ensure that no network or USB cables, other than the network cable
connecting the modem and the wireless router, are connected to the
broadband modem.
NOTE: Restart your wireless equipment in the order described below to prevent a
potential connection failure.
11 Tu rn on only your broadband modem and wait for at least 2 minutes for
the broadband modem to stabilize. After 2 minutes, proceed to step 12.
12 Turn on your wireless router and wait for at least 2 minutes for the wireless
router to stabilize. After 2 minutes, proceed to the step 13.

Dell Inspiron 1720 Specifications

General

Bus type	FSB
Stepping	C0
Tjunction	105 °C
Processor cache	6 MB
Processor cores	2
Processor family	Intel® Core™2 Duo
Processor series	Intel Core 2 Duo T9000 Series
Processor socket	LGA 3647 (Socket P)
Processor codename	Penryn
Processing Die size	107 mm²
Processor frequency	2.5 GHz
Processor cache type	L2
Processor lithography	45 nm
Processor system type	Up
Processor manufacturer	Intel
Processor front side bus	800 MHz
Processor operating modes	64-bit
ECC supported by processor	No
Thermal Design Power (TDP)	35 W
Processor core voltage (AC)	1.062 - 1.150 V
CPU multiplier (bus/core ratio)	12.5
Number of Processing Die Transistors	410 M
HDD speed	5400 RPM
HDD interface	SATA
Card reader integrated	Yes
Display diagonal	17 \
Display resolution	1440 x 900 pixels
Native aspect ratio	16:10
Internal memory	4 GB
Memory clock speed	667 MHz
Internal memory type	DDR2-SDRAM
Memory layout (slots x size)	2 x 2 GB
Discrete graphics card model	NVIDIA GeForce Go 8600M GT
Maximum graphics card memory	0.256 GB
Keyboard layout	QWERTY
Pointing device	Touchpad
Type	PC
Modem speed	56.6 Kbit/s
Wireless technology	802.11n
Bluetooth version	2.0+EDR
Bundled software	Microsoft Works 9.0 - Danish
Operating system installed	Windows Vista Home Premium
Number of battery cells	6
TV-out type	S-Video
Charging port type	DC-in jack
Serial ports quantity	0
USB 2.0 ports quantity	5
AC adapter power	90 W
Processor code	SLAYY
Processor ARK ID	33917
Processor package size	35 x 35 mm

Weight and Dimensions

Depth	293 mm
Width	394 mm
Weight	3450 g
Height (rear)	44 mm
Height (front)	39 mm