Dell Latitude 2110 User Manual

Back to Contents Page
Display Panel/Bracket
Dell Latitude 2110 Service Manual
Removing the Display Panel/Bracket
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the keyboard.
4. Remove the access panel.
5. Remove the display assembly.
6. Remove the display bezel.
7. Open the retention clip and disconnect the display touch-screen cable from the display assembly.
8. Remove the screws that secure the display panel to the display assembly, and then flip over the display panel.
9. Remove the display data cable from the display panel.
10. Remove the display panel from the display assembly.
11. Remove the screws that secure the display bracket, and then remove the display bracket from the display assembly.
Replacing the Display Panel/Bracket
To replace the display panel/bracket, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.

Dell Latitude 2110 Specifications

General

Resolution	1024 x 576
Graphics	Intel GMA 3150
RAM	1GB DDR2
Storage	160GB HDD
Display	10.1-inch
Operating System	Windows 7 Starter
Battery	3-cell
Weight	1.32 kg (2.91 lbs)
Wireless	802.11
Ports	3 x USB 2.0, VGA, Ethernet, Headphone/Microphone combo jack