Dell N2048 User Manual

40 Getting Started Guide
N30xx Series Installation
Site Preparation
N30xx Series switches can be mounted in a standard 48.26 cm (19-inch) rack
or placed on a flat surface.
Make sure that the chosen installation location meets the following site
requirements:
• Power — The switch is installed near an easily accessible 100–240 VAC,
50–60 Hz outlet.
•
Clearance — There is adequate front and rear clearance for operator
access. Allow clearance for cabling, power connections, and ventilation.
•
Cabling — The cabling is routed to avoid sources of electrical noise such
as radio transmitters, broadcast amplifiers, power lines, and fluorescent
lighting fixtures.
•
Ambient Temperature — The ambient switch operating temperature
range is 0 to 45ºC (32 to 113ºF) at a relative humidity of up to 95 percent,
non-condensing.
NOTE: Decrease the maximum temperature by 1°C (1.8°F) per 300 m (985 ft.) above
900m (2955 ft.).
• Relative Humidity — The operating relative humidity is 8% to 85%
(noncondensing) with a maximum humidity gradation of 10% per hour.

Dell N2048 Specifications

General

Model	N2048
Category	Switch
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
RAM	512 MB
PoE	No
Ports	48 x 10/100/1000BASE-T
Uplink Ports	2 x 10GbE SFP+
Additional Uplink Ports	2 x 10G SFP+
MAC Address Table Size	16, 000 entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)