Steps
1. Open the latch and disconnect the touchpad cable from its connector on the system board.
2. Open the latch and disconnect the keyboard-backlight cable from its connector on the system board.
3. Move the touchpad cable off the speaker cable.
4. Peel the tapes that secure the antenna cables to the system board and move the antenna cables off the speaker (woofer)
cables.
5. Disconnect the speakers (woofers) cable from its connector on the system board.
6. Peel the tapes that secure the speakers (woofers) cable to the system board.
7. Remove the speakers (woofers) cables from the routing guides on the palm-rest and keyboard assembly.
8. Lift the speakers (woofers) along with its cables off the palm-rest and keyboard assembly.
Installing the speakers (woofers)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the speakers (woofers) and provides a visual representation of the installation
procedure.
62
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
Need help?
General
