9
4. Place a container with a minimum capacity of 500 ml
under the boiler outlet (A5) (g. 4) and press the
button. Repeat this operation 5 times.
5. Empty the container and put it under the hot water/steam
spout (A12) (g. 4).
6. Turn the hot water/steam dial to the position (g.
5) and deliver to empty the water tank (A3); then turn the
knob to the ○ position.
7. PROGRAMMING THE SETTINGS MENU
To access the menu, make sure the appliance is ready for use,
then press and hold the button for 10 seconds until the
three buttons ash in sequence:
The appliance is now in programming mode.
Set the coee maker as you wish, then exit the settings menu by
waiting for 15 seconds.
Please note:
If no selections are made for 15 seconds, the appliance automat-
ically exits programming and is ready for use again.
7.1 Setting coee temperature
To modify the temperature of the water used to make the coee,
proceed as follows:
1. Access the settings menu;
2. Press the button to enter the coee temperature
selection mode. The lights corresponding to the current
selection come on:
low
medium
high
3. The lights start ashing in sequence;
4. Press the button corresponding to the required
temperature:
low medium high
5. The button ashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
7.2 Setting water hardness
The light (B7) indicating that the coee maker needs descaling
comes on after a period of operation established according to
water hardness.
The appliance can also be programmed according to the hard-
ness of the mains water in the various regions so that descaling
needs to be performed more or less frequently.
Proceed as follows:
1. Access the settings menu;
2. Press the button to enter the water hardness selec-
tion mode. The lights corresponding to the current selec-
tion come on:
soft
medium
hard
3. The lights start ashing in sequence;
4. Press the button corresponding to the water hardness in
your area:
soft water
medium
water
hard water
<10°dH 10°dH - 20°dH >20°dH
<18°fH 18°fH - 36°fH >36°fH
<180mg/l CaCo
3
180-360mg/l CaCo
3
>360mg/l CaCo
3
- The button ashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
7.3 Adjusting auto-o (stand-by)
To save energy, an auto-o function turns the appliance o
when not used for a long period. To turn it back on again, press
any button on the control panel.
1. Access the settings menu;
2. Press the button to enter the auto-o time selection
mode. The lights corresponding to the current selection
come on:
9 min
30 min
3 hours
3. The lights start ashing in sequence;
4. Press the button corresponding to the required time:
9 min 30 min 3 hours