fig. 25
fig. 26
fig. 27
fig. 28
fig. 29 fig. 30 fig. 31
Coffee Maker
10
• Rinse all components and clean the metal filter thoroughly in hot
water using a brush (fig. 25). Make sure the holes in the metal fil-
ter are not blocked. If necessary, clean with a pin (see fig. 26).
• Replace the filter and gasket on the plastic disk as shown in fig. 27.
Make sure to insert the pin on the plastic disk into the hole in the
gasket indicated by the arrow in fig. 28.
• Replace the assembly in the steel filter container (fig. 29), making sure
the pin is inserted in the hole in the support (see arrow in fig. 29).
• Finally, screw on the cap.
Failure to clean as described above invalidates the guarantee.
Cleaning the boiler outlet
About every 200 coffees, the espresso boiler outlet must be cleaned
as follows:
• Make sure the appliance is not hot and that it is unplugged from
the mains;
• Using a screwdriver, unscrew the screw fixing the espresso boiler
outlet (fig. 30);
• Clean the boiler with a damp cloth (fig. 31);
• Clean the outlet thoroughly in hot water using a brush. Make sure
the holes are not blocked. If necessary, clean with a pin (fig.26).
• Rinse under running water, rubbing all the time.
• Replace the espresso boiler outlet, making sure the gasket is cor-
rectly positioned.
Failure to clean as described above invalidates the guarantee.
Other cleaning operations
1. Do not use solvents or detergents when cleaning the coffee
maker. Use a soft, damp cloth.
2. Clean the filter holder cup, filters, drip tray and water tank
regularly.
The drip tray has a red indicator which becomes visible when
the tray needs emptying.
To empty, remove the cup grille (fig. 32), empty the water and
clean the tray with a cloth. Replace the drip tray, making sure
the indicator is correctly positioned.
Clean the tank, using a brush to reach the bottom.
ATTENTION: during cleaning, never immerse the unit in
water – it is an electrical appliance.
To Next Page
Loading...
Need help?
General
