DeLonghi EX Series Instructions For Use

10
DESCRIPTION OF THE REMOTE CONTROL
D1) “ON/STAND-BY” button
D2.1)Temperature decrease / programmed operation button
D2.2)Temperature increase / programmed operation button
D3) “MODE” function button
D4) Fan speed selection button ( )
D5) SWING button (ap swing)
D6) TIMER button
D1
D4
D2.1D2.2
D5
D6
D3
TURNING THE APPLIANCE ON
• Plug into the outlet.
• Press the button (D1) (when turned on, the air con-
ditioner starts operating in the same mode as when it was
turned o) .
• To switch the appliance o, press button (D1) , then
remove the plug.
NOTE: Never switch the appliance o by removing the plug.
Always switch it o by pushing on the button and waiting
few minutes before removing the plug. In this manner, the ap-
pliance can perform operating status checks.
SELECTING THE OPERATING MODES
The commands available on the remote control correspond to
those on the appliance control panel (C).
Therefore, refer to the instructions in the previous chapters.
NOTE: The special functions D5-D6, are available from the re-
mote control only.
SWING BUTTON
The SWING button (D5) moves the grille ap, evenly distributing
the air into the room.
When the SWING button is pressed, the ap will begin to move
alternately forward and back.
If pressed again, the ap will be locked into its current position.
When the button is next pressed, the ap will start to move
forward and back again.
NOTE: in order to avoid damaging the internal mechanisms, the
ap must not be moved manually.
SETTING THE TIMER
The timer allows for the delayed start up or shut down of the
appliance. This function will prevent wasting electricity by opti-
mising the operating periods.
How to program delayed start up
• Plug in the appliance and set to standby.
• Press the timer key (D6): the timer symbol (C10) and hours
(C6) light up.
• Use the + (D2.2) or - (D2.1) key to set the number of hours
until the appliance should start up.
When the set time is elapsed, the appliance will start to operate
in the same operating mode that was previously set.
Start up can be programmed at any time within the 24 hours
that follow. A few seconds after the timer is set, the setting is
acquired. The timer symbol stays lit and the display returns to
standby.
To cancel the timer program, touch the timer key (D6) twice.
The timer symbol (C10) will go o.
How to program delayed shut down
• While the appliance is on in any operating mode, delayed
shut down can be programmed.
• Press the timer key (D6): The timer symbol (C10) and hours
(C6) light up.
• Use the + (D2.2) o - (D2.1) key to set the number of hours
until the appliance will shut down.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays
lit.
Once the set time is elapsed, the air conditioner goes into standby.
To cancel the timer program, touch the timer key (D6) twice.
The timer symbol (C10) will go o.

DeLonghi EX Series Specifications

General

Brand	DeLonghi
Model	EX Series
Category	Air Conditioner
Language	English