24
4. Press the two coloured release buttons inwards, at the same
time pulling the infuser outwards;
PUSH
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO DETERGENTS NO DISHWASHER
6. Do not use detergents when cleaning the infuser, as they
could damage it.
7. Use the brush to remove any coee residues left in the
infuser housing, visible through the infuser door;
8. After cleaning, replace the infuser by sliding it onto the
internal support, then push the PUSH symbol fully in until
it clicks into place;
Please note:
If the infuser is dicult to insert, before insertion, position it
correctly by pressing the two levers.
9. Once inserted, make sure the two coloured buttons have
snapped out;
PUSH
10. Close the infuser door;
11. Put the water tank back.
12. DESCALING
To complete the descaling cycle correctly, pay close atten-
tion to the quantities required in the water tank for each
step:
Step 1: Descaling
action
+
Step 2: First rinse
Step 3: Second rinse
• Before use, read the instructions and the labelling on the
descaler pack.
• Use De’Longhi descaler only. Using unsuitable descaler
and/or performing descaling incorrectly may result in
faults not covered by the manufacturer’s guarantee.
• Descaler can cause damage to delicate surfaces. If the
product is accidentally spilt, dry immediately.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
