29
ENGLISH
Operation
SWITCHING THE APPLIANCE ON
Connect the appliance to the mains supply.
On the display two lines will appear indicating Stand-by mode
Press the ON/OFF button (A) and then the MODE button until the
relevant function indicator appears viz.:
Indicator C : air-conditioning
Indicator D : dehumidifying
Indicator E : purification/ventilation
AIR-CONDITIONING FUNCTION
This function is ideal in hot, humid weather conditions when the
atmosphere requires to be cooled and dehumidified.
To ensure proper function of the appliance, after selecting the
air-conditioning function, press buttons + (F) or – (G) until the desi-
red temperature appears on the display.
The temperatures most suited to the atmosphere in summer vary
between 24 and 27°C. We do not advise selection of tempera-
tures much lower than those outside.
Select fan speed by pressing the “FAN” button (Q) until the fan
speed indicator appears:
MAX (P): if you want the maximum power of the air-conditioner
to reach the desired temperature as quickly as possi-
ble.
MIN (O): if you want to reduce the level of noise and still main-
tain a good level of comfort.
SILENT (N): when minimum noise is required,
AUTO (M):if you prefer the appliance to select the fan speed for
the temperature selected on the display panel.
DEHUMIDIFYING FUNCTION
This function is ideal for reducing humidity in the atmosphere
while avoiding increases or decreases in temperature (in
between seasons, damp places, wet spells of weather).
When you select the dehumidifying function, the letters “ ” will
appear on the display.
Model FX160ECO: the water is collected in the tank at the rear of
the appliance.
When the tank is full, the appliance will stop working and the
display will show the letters “ ” (Full Tank); the tank must then
be emptied. When it is re-inserted, the appliance will re-start
automatically. N.B. remove the air exhaust hose (13).
Mod. FX400ECO: l’acqua viene in parte smaltita per evaporazio-
ne sull’unità esterna; è consigliabile comunque provvedere a
predisporre l’unità esterna con il raccordo di drenaggio, come
indicato in fig. 16.
Una volta selezionata la funzione Deumidificazione, non è possi-
bile cambiare la velocità della ventilazione, ma l’apparecchio
sceglie automaticamente la modalità di ventilazione.
To Next Page
Loading...
Need help?
General
