24
Operation
SETTING THE TIMER
The timer can be used to delay appliance start up or shut down.
This avoids wasting electricity by optimising operating periods.
To set, press the “+” (G) or “-” (O) button to increase or decrea-
se by an hour at a time. When the buttons are held down for
more than two seconds, the time runs rapidly up to a maximum
of 24 hours.
How to programme delayed start up
• Plug the appliance into a mains socket and press the ON/OFF
button (A), then select the required mode and operation
(temperature, fan speed, etc).
•Press the ON/OFF button (A) again to place the appliance in
standby mode.
•Press the timer button (L). The two centre segments flash on
the display.
•Use the “+” (G) or “-” (O) buttons to set the number of hours
delay before the appliance comes on.
• The indicator light (H) flashes until the appliance starts up.
•You can set the appliance to come on with a delay of up to
24 hours.
How to programme delayed shut down
• Delayed shut down can be programmed in any operating
mode (air conditioning / superconditioning / dehumidifying /
fan / air purifying).
•Press the timer button (L). The two centre segments flash on
the display.
•Use the “+” (G) or “-” (O) button to set the number of hours
delay before the appliance goes off.
• The indicator light (H) flashes until the appliance shuts down.
At the set time, the air conditioning unit shuts down and
remains in standby.
To Next Page
Loading...
Need help?
General
