STANDBY/ PERSONALISED SETTINGS
B
A D
C
If the machine is not used for 3 minutes, the lights
on buttons A, B, C and D will go out. The Delta Q logo
will remain lit with a white light in standby mode.
Press any button (A, B, C or D) to return to the Ready to Use Mode.
The machine will automatically heat up the system.
STANDBY
Removing the drip tray will not wake the device up.
PERSONALISED SETTINGS
If button A is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 75cc.
If no button is pressed for 1 minute, the machine will return to Ready to Use Mode and will
memorise the last volume set.
Programming the espresso extraction button
When in ready to use mode, press button A for more
than 3 seconds.
Button A will light up green and buttons B, C and D will start
to ash green.
Insert a Delta Q capsule into the capsule holder.
Press button A to start the espresso extraction process.
The button A will start to ash.
Press button A again to stop the extraction process.
The machine will memorise the volume extracted.
Button A will then extract this new volume.
After extraction, the machine will return to Ready to Use Mode.
Programming the lungo extraction button
The steps are the same as for predening an espresso.
Press button B instead of button A.
If button B is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 75cc.
Programming the tisane extraction button
The steps are the same as for predening an espresso.
Press button C instead of button A.
If button C is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 200cc.
If button C is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 200cc.
— 09 —
EN
B
A
C
B
A
C
To Next Page
Loading...
Need help?
General
