5
3. Slide slotted end (E) Fig. 7, of lower guard mounting
bracket under screw head (D). Make sure screw and
spacer (K) is engaged with slot (L) in guard lifting lever
and rotate lower guard mounting bracket (F) until hole (G)
in bracket lines up with threaded hole (H) in upper guard.
4. Replace screw (C) Fig. 8, that was removed in
STEP 2. Tighten screw (D) and screw (C).
ASSEMBLING DUST BAG
Assemble dust bag assembly (A) Fig. 9, to dust spout (B)
on rear of upper guard assembly, as shown.
FASTENING COMPOUND MITER
SAW TO SUPPORTING SURFACE
CAUTION: Before operating your compound miter saw,
make sure it is firmly mounted to a sturdy work bench or
other supporting surface. Four holes are provided, two
of which are shown at (A) Fig. 10, for fastening the saw
to a supporting surface.
When frequently moving the saw from place to place,
we suggest that the saw be mounted to a 1/2" or 3/4"
piece of plywood. The saw can then be easily moved
and the plywood clamped to the supporting surface
using “C” clamps.
Fig. 10
Fig. 9
Fig. 8
Fig. 7
L
H
F
G
K
D
E
C
D
B
A
A
To Next Page
Loading...
Need help?
General
